Abus FU8330 Instructions d'exploitation télécharger pdf (Page 11)

11

Installation

Open the housing of the wireless

transmitter. Loosen the fastening screw on

the PCB, then lift the PCB carefully out of

the housing. Install the wireless transmitter

at the selected location. Screw the rear part

of the detector housing to the wall. Fasten

the PCB back into the housing, then insert

the lithium battery provided with the correct

polarity. Connect the cable of the water

sensor to the screw terminal of the

transmitter.

Fastening the water sensor:

Choose a location that will be flooded very

quickly in the event of water penetration.

Change the wireless transmitter settings as

required using the jumpers.

Setting possibilities

Jumper: Disable Tamp

The tamper contact on the detector is

inactive when this jumper is attached. You

can then open the detector housing without

triggering a tamper alarm.

Jumper: Disable View State

The LED lights up as soon as the sensor

detects water when this jumper is attached.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 42 43

Funk-Wassermelder 1

Commentaires sur ces manuels

Pas de commentaire